How To Repair Cracked Rifle Stock

Being able to repair a croaky, chipped or broken shotgun stock is a valuable piece of knowledge for almost hunters and shooting sports participants. Far too often, a perfectly adept walnut stock is scrapped for a new ane because of damage that could hands be repaired by its possessor.

Items you will demand

• Four fashion spiral driver

• Long-handled, flat-head screwdriver

• Finish rubber solvent/cleaner

• Loftier-quality wood glue

• Clamp

• Drill

• Pocket-size-diameter drill bit

• Super glue

• Small-diameter wire brad nail

• Wire cutters

• Metal file

Step one

Remove Mounting Bolt

Remove the stock and so you don't damage the metallic and bluing of the shotgun. Accept off the barrel plate. You should run into the bolt hole for the mounting bolt. Usually, the mounting bolt tin exist removed with a long-handled, flat-caput screwdriver. Once the bolt is removed, you should be able to pull the stock from the mounted position.

Step 2

Remove Whatsoever Tape

Remove any record or wrapping that may be on the stock. Thoroughly make clean the expanse to be repaired. Use an sometime rag and a finish safe remover or solvent. Brand sure to follow the directions of whatsoever solvent that you use, and permit the expanse dry before continuing the repair.

Pace 3

Clench and Let Dry

Make sure the cracked or broken piece is in the correct position. Use a high-quality wood glue to glue it in its place. Immediately identify the clamp correctly over the area, and tighten every bit much as possible without damaging the wood. Make sure to use the glue every bit directed on the bottle, and permit drying completely. Let information technology dry while clamped for 24 hours. After the gum has dried, carefully remove the excess glue that has expanded through the drying process.

Step 4

Pilot Hole

Drill a pilot hole, slightly smaller in diameter than the wire brad nails, on each side of the fissure or break. Drill deep enough and then you reach the good wood, but not so deep that yous will completely sink the nail. You want a small portion of the nail sticking out of the hole for now.

Step 5

Finished Repair

Place a small amount of the super glue on each brad nail, and slowly button them into the pilot holes. Every bit stated in the previous footstep, you should have a minor portion of the nail sticking out of the hole. Later the mucilage has dried, yous tin cut this portion off with wire cutters and file down with a metal file, being careful non to harm the wood. Once this is complete, reverse Step 1 to reattach the stock, making certain to tighten the mounting bolt thoroughly.

Warnings

• Like whatever repairs involving a firearm, make sure to unload the shotgun before handling. If the damage to the wood seems too astringent or seems to interfere with the condom or operation of the gun, then take information technology to a professional gunsmith for the repair.
• The author is non a professional or licensed gunsmith. However, in the author's experience, this repair works for most simple cracks or breaks.

Tips

• This process can also be used to repair small cracks, chips and breaks on wooden article of furniture likewise.
• When using the clamp, yous tin can identify a protective rag or textile betwixt it and the wood to help prevent damage. However, be mindful of the glue.

Tips

• This process tin can also exist used to repair small cracks, chips and breaks on wooden furniture equally well.
• When using the clamp, you lot can place a protective rag or cloth between it and the wood to assist prevent damage. All the same, be mindful of the glue.

Warnings

• Like any repairs involving a firearm, make certain to unload the shotgun earlier treatment. If the damage to the forest seems also severe or seems to interfere with the safety or functioning of the gun, and then take it to a professional gunsmith for the repair.
• The author is not a professional or licensed gunsmith. However, in the author's experience, this repair works for most unproblematic cracks or breaks.

Author Bio

This article was written by a professional person author, copy edited and fact checked through a multi-point auditing system, in efforts to ensure our readers merely receive the best information. To submit your questions or ideas, or to simply larn more than, see our near us page: link below.

Source: https://goneoutdoors.com/repair-cracked-broken-shotgun-stock-4690624.html

Posted by: harristhistoll.blogspot.com

Share this post